Úvodní stránka » Advertising & Marketing » FORMING AND BENDING


The finished product can sometimes feature special shapes, such as deep drawing or folds at the ends, to be implemented in the production line.

Through the realization of suitable forming stations/ molds, we can complete the products without the need for later off-line processing.

Bending is a metal forming process in which a force is applied to a piece of sheet metal, causing it to bend at an angle and form the desired shape. A bending operation causes deformation along one axis, but a sequence of several different operations can be performed to create a complex part.

In press brake forming, a workpiece is positioned over the die block and the die block presses the sheet to form a shape. Usually bending has to overcome both tensile stresses and compressive stresses. When bending and forming is done, the residual stresses cause the material to spring back towards its original position, so the sheet must be over-bent to achieve the proper bend angle. The amount of spring back is dependent on the material, and the type of form. When sheet metal is bent, it stretches in length. The bend deduction is the amount the sheet metal will stretch when bent as measured from the outside edges of the bend. The bend radius refers to the inside radius. The formed bend radius is dependent upon the dies used, the material properties, and the material thickness.

Bending machines are developed for high flexibility and low setup times. Those machines are able to bend single pieces as well as small batches with the same precision and efficiency as series-produced parts in an economical way.


High-quality electronic components determine product performance and the reliable failure rate is low

Integrated design, high-intensity mobile track design, durable and easy to operate

Fine work quality assurance

Processing accuracy and high efficiency

Napsat komentář

Vaše e-mailová adresa nebude zveřejněna. Vyžadované informace jsou označeny *


− 4 = čtyři