Superfine grinding bearing into the powder reasons
|18.10.2017||Posted by emmas1028 under Nezařazené|
ultrafine mill grinding production, if there is the phenomenon of bearing into the powder, it will cause its internal lubricants pollution, not only can not play the role of lubrication, but also exacerbate its wear and tear, it will make its life reduced, and increase Production failure in the probability of occurrence, for this phenomenon, we need to find the reasons for the timely into the powder, and then targeted to solve.
In general, the reason why the bearing into the powder is mainly due to two factors, one is the lack of lubricating oil seal may be damaged; Second, the lack of long-term repair and finishing equipment, then find the reasons, we can The implementation of the solution, according to the above mentioned two aspects of the reasons, the solution is mainly as follows: For the lack of lubricating oil seal may be the phenomenon, we use ultra-fine milling equipment .
The need for regular addition of lubricating oil to prevent the phenomenon of insufficient oil, and for the seal ring damage phenomenon, the general is due to long-term workload caused, which will cause the phenomenon of lax, so that dust into the Bearing the internal, the solution is to replace it, while the use of equipment in the process, the regular inspection of the sealing problem, but also a very good way to prevent the occurrence of lax phenomenon; for the lack of long-term repair and finishing equipment In order to reduce the phenomenon of bearing into the powder, we need to regularly repair the bearing, if the wear Heavy, need to be replaced, so as to effectively prevent its greater impact on production caused.